McIntosh UR12 - Manual (Page 16)

16
The MACRO and PUNCH THROUGH
can be programmed. There are three types
of macro functions you can program. The
M1, M2 and M3 in the Main Menu are de-
signed to send out up to twenty eight com-
mands from each of the three Touch-but-
tons. There are Twelve Device Touch-but-
tons in the Main Menu and fourteen avail-
able commands from each device button.
With the Favorite Channel Buttons you
can create and design up to 60 buttons for
your Favorite Button in the Video Modes.
Each favorite channel button can send out
up to fourteen commands with one button
press. Refer to figures 9 and 10.
Programming Macro Functions
Press MACRO PROGRAM button in 2.
SYSTEM & OPTIONS Move the cursor
on the LCD either to the COMMON BUT-
Introduction Macro and Punch
Through Programming
TON to program M1, M2 and M3 and fa-
vorite channel buttons or to the DEVICE
BUTTON to program the device buttons
by using MUTE button. Press the button
you wish to program and follow proce-
dures shown below:
M1, M2 and M3 Buttons
1. Select one of the three Macro Touch-
buttons, M1 – M3, with the cursor on
DEVICE BUTTON.
2. Select functional buttons you wish to
store in the Macro Touch-button. You
can store up to 28 commands.
3. Store the commands you selected to
the macro button by pressing CH (UP)
push-button. To cancel the macro com-
mands, press CH (DOWN) Push-but-
ton.
Figure 10
C D
Figure 9