McIntosh UR12 - Manual (Page 19)

19
System Settings
ming. If there is more than one code
number assigned to your brand, try one
code number at a time until you find
the right code number. If you entered
the right code number, the component
will turn off right after you entered the
number. When the right code number
is entered, save the code by pressing
the SAVE button on Touch-button.
8. Confirm that you entered the right
code number that matches your com-
ponent by pressing other buttons such
as POWER, VOLUME, MUTE and
CHANNEL. If any of the buttons do
not operate as they should, please re-
peat from Step 5.
9. Continue to program other components
by repeating from the above step 5.
10. Once you complete programming all
the devices, exit from the program-
ming mode by pressing both the
MAIN and PAGE buttons simulta-
neously.
11. You will be in the setting mode once
again. Move the cursor to 8. TO EXIT
and press the cursor down or simply
press the MAIN button to exit to main
menu.
Auto Scan with Brand Names
1. Manually turn on the component you
plan to operate.
2. Go to program setting mode in the re-
mote control by pressing both the
MAIN and PAGE buttons simulta-
neously for five seconds.
3. Using the joystick, move the cursor
down in the Touch Screen to 3. PRE-
PROGRAM.
4. Push the joystick down to enter the
preprogram mode.
5. Select the device you wish to program
in the Touch Screen (eg. To program
TV, press the TV Device Touch-but-
ton).
6. Select the device from which the three
digit code number will be selected
from (eg. If it is from the TV code
table, press the TV Device Touch-but-
ton).
7. Point the remote control to the compo-
nent and press the BRAND button.
8. Press the number button on the Touch
Screen that corresponds with the first
alphabetical character of your brand
name. Please press the number button
within 20 seconds of programming.
Please note that pressing the number
Figure 12