McIntosh UR12 - Manual (Page 22)

22
in the Device Touch-button, move the
cursor to DEVICE BUTTON.
4. Press the functional button or Device
Touch-button you wish to erase for
three seconds or more and it will flash
“ERASED”. Repeat this step for other
buttons you wish to erase.
5. Once you completed erasing and wish
to exit from this mode, press the
MAIN button to go back to the main
page of the learning mode. Exit from
the Main page by pressing both the
MAIN and PAGE buttons simulta-
neously.
6. You will be in the setting mode once
again. Move the cursor to 8. TO EXIT
and press down the cursor or simply
press the MAIN button to exit to the
main menu.
Erase all the learned commands in a single
device
1. Go to the program setting mode by
pressing both the MAIN and PAGE
buttons simultaneously for five sec-
onds.
2. Move the cursor to 4. LEARNING
with the joystick and then push the
joystick down to enter the learning
mode.
3. Press the MUTE button to move the
cursor to the DEVICE BUTTON and
keep the Device Touch-button you
wish to erase all the learned com-
mands down for five seconds until the
Touch-button shows ERASED. This
will erase the function taught in the
Device Touch-button. If you continue
to press the Device Touch-button for
another five seconds, it will erase all
the functions in the device.
4. Once you complete the erasing and
wish to exit from this mode, press the
MAIN button to go back to the main
page of the learning mode. Exit from
the Main page by pressing the MAIN
and PAGE buttons simultaneously.
5. You will be in the setting mode once
again. Move the cursor to 8. TO EXIT
and press down the cursor or simply
press the MAIN button to exit to the
main menu.
Erase all the learned commands in all
twelve devices
1. Go to the program setting mode by
pressing both the MAIN and PAGE
buttons simultaneously for five sec-
onds.
2. Move the cursor to 4. LEARNING
with the joystick and then push the
joystick down to enter the learning
mode.
3. Press both the POWER and STOP but-
tons simultaneously for five seconds in
the learning mode. The Touch-button
will show ERASED after it erased all
the learned commands in the remote
control.
4. Once you complete the erasing and
wish to exit from this mode, press both
the MAIN and PAGE buttons simulta-
neously.
5. You will be in the setting mode once
again. Move the cursor to 8. TO EXIT
and press down the cursor or simply