McIntosh UR12 - Manual (Page 28)

28
Program Loading Setting the Date and Clock
Figure 19
1. Enter the Setting mode by pressing
both the MAIN and PAGE Push-but-
tons simultaneously for five seconds.
2. Move the cursor on the Touch Screen
to 6. SET DATE & CLOCK by using
the joystick. Enter this mode by push-
ing the joystick down. Refer to figure
19.
3. Press the selection you wish to change
from the Touch Screen and change it
using the UP and DOWN buttons.
Once you complete the settings, store
them by pressing the SAVE button.
This program enables you to both up load
the program to PC as well as down load
from PC using the UR12 Upload Data
Cable.
1. Connect the 1/8 inch stereo mini phone
plug end of the Upload Data Cable to
the jack on the bottom end of the
UR12 Remote Control. Refer to figure
21.
2. Connect the DB9 connector end of the
Upload Data Cable to the Serial Com
Port on the computer.
1. Enter the Setting mode by pressing
both the MAIN and PAGE Push-but-
tons simultaneously for five seconds.
2. Move the cursor on the Touch Screen
to 7. PROGRAM LOADING by us-
ing the joystick. Enter this mode by
pushing the joystick down. Refer to
figure 20.
PC INTERFACE
OPERATING PROGRAM
LEARNED PROGRAM
PROGRAM VERSION _ . _ _
UP LOAD
DOWN LOAD
UP LOAD
DOWN LOAD
Figure 20