Multiquip Diamond Back SP3 Street Pro Professional Slab Saw 35 HP Wisconsin Diesel Engine SP303530 - Manual (Page 14)

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 12
MQ SP-3035 CONCRETE SAW
General Safety Warnings
WARNING
 ALWAYS read, understand, and follow procedures in the Operator’s
Manual before attempting to operate the equipment.
 Be sure the operator is familiar with proper safety precautions and
operating techniques before using the saw.
 Make sure the operating area is clear before starting the engine.
 Maintain this equipment in a safe operating condition at all times
 Keep the saw clean. It will work better and last longer
 Use proper blades and follow the blade manufacturer’s
recommendations. Match blade rpm (Spindle rpm) to recommended
blade surface feet per minute (SFPM).
 Tighten the 5/8” blade-mounting bolt to 100-125 foot-lbs. torque.
 Turn engine OFF prior to fueling the saw!
 Start engine with the joystick in NEUTRAL to prevent unexpected saw
movement .
 Do not leave saw unattended while engine is running.
 Do not start engine on a sloping surface to prevent unexpected loss of
control.
 Do not park or leave saw unattended on a slope - the saw can roll when
the engine is OFF. Block the unit when leaving.
 If the saw must be parked on a slope, turn it across the angle of the
slope, to prevent accidental downhill movement.
 Prior Always store equipment properly when not being used. Equipment
should be stored in a clean, dry location out of the reach of children.
When storing the saw in freezing weather, blow out water lines to
prevent damage to components in the water delivery system.
 Prior to service, level the frame surface
.
 Do not over tighten the Spindle drive belt
 Turn on water flow prior to starting the engine, to prevent damage to the
impeller of a belt-driven water pump.
 Don’t pollute! Waste oils and other chemicals must be disposed of in a
manner consistent with local and state environmental protection
regulations.