Multiquip Diamond Back SP3 Street Pro Professional Slab Saw 35 HP Wisconsin Diesel Engine SP303530 - Manual (Page 48)

MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 46
MQ SP-3035 CONCRETE SAW
DANGER
Ensure the Outer Flange is in place to prevent the
Puller and Inner Flange from flying off when the taper
breaks loose, and causing injury!

NOTE
If the Inner Flange does not readily come free from the tapered
Spindle, lightly tap on the central Puller bolt. This should cause
the flange to break free from the shaft.
Installing the Inner Blade Flange
1. Ensure that the tapered portion of the Spindle, and the Inner Spindle are perfectly clean and
free of burrs or indentations. Clean and repair as necessary.
2. Ensure that the Drive Key is in place.
3. Slide the Inner Flange onto the tapered portion of the Spindle.

NOTE
Do Not use any lubricant! Lubricant prevents the tapered
surfaces of the Flange and Shaft from mating properly
.
4. Install the Outer Blade Flange, Flange Bushing, and Mounting Bolt.
5. Tighten with a ½” impact wrench to seat the tapered surfaces of the Inner Flange and Spindle.
Fig. 32 — Installing the Inner Spindle
Drive Key
Spindle
Inner
Outer Flange
Flange Bushing
Dowel pin