Mq sp-3035 concrete saw water supply and control – Multiquip Diamond Back SP3 Street Pro Professional Slab Saw 35 HP Wisconsin Diesel Engine SP303530 User Manual
Page 28
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 26
MQ SP-3035 CONCRETE SAW
Water Supply and Control
WARNING
To prevent damage to the impeller of a belt driven water pump, do
not run the engine with the water pump switch on, unless the water
supply is connected and water is flowing.
When storing the saw during freezing weather, blow out the water
lines to prevent damage to the water delivery system.
Connect the job water hose to the water inlet fitting on the left side of the saw.
Verify that the water hose on the saw is connected to the Blade Guard and that the water delivery
tubes are pointed into both lower Blade Flanges.
The yellow lever on the control panel regulates water flow volume.
If the saw is equipped with an optional water pump, the ON/OFF switch is on the control panel
next to the water flow control valve.
NOTE
Because of the water delivery efficiency of the 24-port blade flanges,
these saws use less water for blade cooling and flushing than other
saws.
Fig. 12 — The Water Supply System
Pump
ON/OFF
Switch
Water Inlet
Optional
Water Pump
Hose to
Blade Guard
Flow Control
Lever