Remote control functions: care and operation, Important, Installing batteries – MITSUBISHI ELECTRIC PD-4225S User Manual
Page 18: Operation
18 Plasma TV
Remote Control Functions: Care and Operation
Remote Control Functions: Care and Operation
- When using the remote control, aim it at the remote control sensor on the TV.
- Under certain conditions such as if the remote IR signal is interrupted, the remote control may not function. Press the key again
as necessary.
Installing Batteries
Installing Batteries
POWER
PAUSE
REC
3
6
9
QV
DEVICE
MENU
CANCEL
FORMAT
PIP CH
1
7
SQV
4
GUIDE
2
5
8
0
TV MENU
PIP
HOME
MUTE
DEVICE
CH
VOL
REW/REV
FF/FWD
PLAY
STOP
EXCH
ZOOM+
INFO
SLEEP
AUDIO
VIDEO
PIP DEVICE
ZOOM–
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
MTS
size AA
batteries
Installing the Batteries:
(Figure 2)
1. Remove the remote control’s back cover by gently pressing the
ridged tab in the direction of the arrow and sliding off the cover.
2. Load the batteries, making sure the polarities (+) and (-) are cor-
rect. For ease of installation, install the negative (-) side first.
For Best Results from the Remote Control:
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time unless
instructed to.
• Do not allow to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft, lightly
moistened cloth.
• Do not mix new and old batteries.
• Do not heat, take apart, or throw batteries into fire.
• Use only AA batteries.
You can use the remote to control the TV, CABLE/DBS/DTV, VCR,
DVD, and AUDIO products. Select the product you want to control
by moving the slide switch to the appropriate position. The remote
control has been preset to operate the TV and other Mitsubishi prod-
ucts. To program the remote control to operate other products, see
Use of the Remote Control with Other A/V Products, page 20.
Figure 2. Installing the batteries.
Figure 1. Remote Control Functions.
Operation
Operation
Operating the Remote Control:
Operating the Remote Control:
IMPORTANT
The remote control may return to its initial setting
when the batteries are changed. You may need to
reprogram.