MITSUBISHI ELECTRIC PD-4225S - Manual (Page 44)

44 Plasma TV
No. Pin name
1 No connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE side ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
1
5
6
9
2
3
5
4
6
7
8 RXD
TXD
GND
DTR
DSR
RTS
CTS
TXD
RXD
GND
DSR
DTR
CTS
RTS
PC
7-Wire Configurations
(Standard RS-232C cable)
D-Sub 9
3
2
5
6
4
8
7
Plasma TV
D-Sub 9
2
3
5
4
6
7
8 RXD
TXD
GND
DTR
DSR
RTS
CTS
TXD
RXD
GND
DTR
DSR
RTS
CTS
PC
3-Wire Configurations
(Not standard)
D-Sub 9
3
2
5
4
6
7
8
Plasma TV
D-Sub 9
- Connect the MONITORLINK CONTROL/RS-232C input jack to an external control device (such as the
Mitsubishi HD-5000 Receiver/Controller or an A/V control system) and control the TV’s functions externally.
- Connect the serial port of the control device to the RS-232C jack on the TV back panel.
- RS-232C connection cables are not supplied with the TV.
- NOTE: Not all cables shown are included with the TV. They are available at most consumer electronics stores.
T T ype of Connector; D-Sub 9-Pin Male ype of Connector; D-Sub 9-Pin Male
RS-232C Configurations RS-232C Configurations
External Control Device Setup External Control Device Setup
MONIT MONIT ORLINK/RS-232C Setup ORLINK/RS-232C Setup
HD-5000
(FACTORY INSTALLED)