Multi-Tech Systems MT2834ZPX - Manual (Page 26)

26
MT2834ZPX Owner's Manual
COMMAND: &Cn
VALUES: n = 0, 1, 2 or 4
DEFAULT: &C1
DESCRIPTION:
&C0 forces Carrier Detect on.
&C1 lets Carrier Detect act normally.
&C2 lets Carrier Detect drop S24 time on disconnect.
&C4 resets modem when Carrier Detect drops.
COMMAND: &CDn
VALUES: n = 0 or 1
DEFAULT: &CD0
DESCRIPTION:
&CD0 execute cleardown on disconnect.
&CD1 do not execute cleardown on disconnect.
COMMAND: Ds
VALUES: s = phone #
DEFAULT: n/a
DESCRIPTION:
Dial a telephone number “s”, where s may
include up to 60 digits or T, P, R, comma and ; characters.
COMMAND: DsNd
VALUES: s = phone # and d = 0 thru 9
DEFAULT: n/a
DESCRIPTION:
Store telephone number. To store, phone number ”s“ is en
entered and followed by N and then Directory Number “d.”
COMMAND: &Dn
VALUES: n = 0 thru 3
DEFAULT: &D2
DESCRIPTION:
&D0 means DTR is ignored
&D1means modem returns to command mode.
&D2 lets modem react to DTR normally.
&D3 causes modem to reset to modem default parameters.
COMMAND: $Dn
VALUES: n = 0 or 1
DEFAULT: $D0
DESCRIPTION:
$D0 disables DTR Dialing.
$D1 enables DTR Dialing.