Multi-Tech Systems MT2834ZPX - Manual (Page 27)

27
Chapter 4 - AT Commands, S-Registers and Result Codes
COMMAND: %DFn
VALUES: n = 0 or 1
DEFAULT: %DF0
DESCRIPTION:
%DF0 selects V.34 Line Probe Data in Graph Format.
%DF1 selects V.34 Line Probe Data in Table Format.
COMMAND: %DPn
VALUES: n = 0 or 1
DEFAULT: %DP0
DESCRIPTION:
%DP0 selects not to read Line Probe Information from
DSP during handshaking.
%DP1 selects read Line Probe Information
from DSP during handshaking.
COMMAND: >DTn
VALUES: n = 0 or 1
DEFAULT: >DT0
DESCRIPTION:
>DT0 disables modem detecting DTMF tones.
>DT1 enables modem detecting and reporting DTMF tones
when it is off-hook.
COMMAND: En
VALUES: n = 0 or 1
DEFAULT: E1
DESCRIPTION:
E0 selects do not echo Command mode characters.
E1 selects echo Command mode characters.
COMMAND: $EBn
VALUES: n = 0 or 1
DEFAULT: $EB0
DESCRIPTION:
$EB0 selects 10 bit mode.
$EB1 selects 11 bit mode.
COMMAND: &En
VALUES: n = 0 thru 15
DEFAULT: &E1, &E4, &E6, &E10, &E13, &E15
DESCRIPTION:
&E0 selects no error correction.
&E1 selects V.42 Auto-reliable Mode.
&E2 selects V.42 Reliable Mode.