Multi-Tech Systems MT2834ZPX - Manual (Page 39)

39
Chapter 4 - AT Commands, S-Registers and Result Codes
TABLE 4-1 (Cont'd). Remote Configuration Operation Procedures
You can now use any AT commands of the modem
being remotely configured as if they were being
entered locally. You cannot change the Set-up of the
LOGIN Password until you enter the proper LOGIN
Password.
Step Procedure
4. When you are done entering AT commands and you
want to exit, type
AT0 and hit RETURN. The modem
responds with:
1. DATA Mode
2. COMMAND Mode
5. Enter a 1 to go back on-line with your computer, or
enter 2 and the correct password to talk to your
modem.
Password Commands
COMMAND: #Ixxxxxxxxxx
VALUES: n/a
DEFAULT: #IMULTITECH
DESCRIPTION:
Login Password is any keyboard characters (x) (upper/lower
case sensitive), minimum 6 and maximum 10 characters.
The default Login Password is #IMULTITECH.
COMMAND: #Syyyyyyyyyy
VALUES: n/a
DEFAULT: #SMODEMSETUP
DESCRIPTION:
Set-up Password is any keyboard characters (y) (upper/
lower case sensitive), minimum 6 and maximum 10 charac-
ters. The default Set-up Password is #SMODEMSETUP.