Miller Electric XR A - Manual (Page 17)

OM-1581 Page 13
4-6. Air-Cooled Gun Connections
3
1 Gun Control Cable
Insert plug into Gun Control recep-
tacle, and tighten threaded collar.
2
Gas Hose
Connect to Gas fitting on feeder.
3
Weld Cable
4 Weld Cable Terminal In
Feeder
Connect gun weld cable to weld
cable terminal in feeder.
5
Wire Conduit
6 Thumbscrew
7 Wire Conduit Block
8 Strain Relief
.
For guns that have wire con-
duits with replaceable liners,
the strain relief will need to be
removed from the control box.
Loosen thumbscrew, and insert
conduit through wire opening until
it bottoms against block. Trim liner
if necessary, as close to the rolls
as possible. Tighten thumbscrew.
Close and latch door.
145 432-C / Ref. 802 536-E / Ref. 151 778-B
Tools Needed:
5/8, 3/4 in
4
3
7
6 5
1
2
5
Left Side
8