Miller Electric XR A - Manual (Page 18)

OM-1581 Page 14
4-7. Water-Cooled Gun Connections
1 Gas Hose
Connect to Gas fitting on feeder.
2
Water Hose
Connect to water to gun fitting on
feeder (left-hand threads).
3
Wire Conduit
4 Thumbscrew
5 Wire Conduit Block
Loosen thumbscrew, and insert
conduit through Wire opening until
it bottoms against block. Trim liner
if necessary, as close to the rolls
as possible. Tighten thumbscrew.
6
Gun Control Cable
Insert plug into gun control recep-
tacle, and tighten threaded collar.
7
Strain Relief
Remove strain relief as shown.
8
Power/Water Cable
9 Strain Relief
.
For guns that have wire con-
duits with replaceable liners,
the strain relief will need to be
removed from the control box.
Route cable through strain relief
and connect to weld/water from gun
outlet on feeder. Reinstall strain re-
lief. Close and latch door.
Ref. 802 536-E / Ref. 151 778-B / 152 456-A
1
2
3
6
8
7
4 3
5
5/8, 1-1/8 in
Tools Needed:
Left Side
9