MITSUBISHI ELECTRIC LT-4260 - Manual (Page 24)

23
Wall Mount Configuration Setup
1. Before performing work make sure to disconnect the AC Power cord from the 42" LCD Display.
2. Before performing work spread the protective sheet, which was wrapped around the display, on a flat,
even surface. This will prevent the display from being damaged.
3. Gently lay the LCD Display face down on the protective sheet.
4. Do not touch or hold the screen face while carrying the display.
5. Remove the screws indicated by the arrows. Remove the stand cover.
CAUTION
• Mitsubishi recommends that only qualified service personnel mount the LCD display. Customers
should not attempt to do the work themselves. Mitsubishi bears no responsibility for improper
mounting or mounting that results in an accident or injury.
• Carefully read the installation instructions that come with the wall mount before starting
installation.
����������������
When the HD-6000 is connected to the 42" LCD,
the HD-6000 front control buttons are inactive.
To control the HD-6000 (and 42" LCD), set the
remote control to the CABLE/DBS/DTV Layer
or use control buttons located on the side of the
LCD Display.