Miller Electric MOG-350 - Manual (Page 18)

OM-808 Page 14
3-5. Female Camlok Connector Assembly
sb6.6* – ST-159 028
1 Weld Input Cable
Strip insulation as shown.
2 Copper Strip (Two Included)
3 Connector Body
Wrap strip around bare weld cable
(use two on small diameter cable),
and insert into connector body.
4 Setscrew
Tighten setscrew against copper
strip.
5 Handle
6 Pin
Slide handle over connector body
so holes align; secure by tapping
pin into place.
1 2
3
4
5
6
1 in
(26 mm)
Tools Needed:
7/32 in
3-6. Male Camlok Connector Assembly
sb6.4* 11/92 – ST-155 015
1 Weld Output Cable
Strip insulation as shown.
2 Copper Strip
3 Connector Body
Wrap strip around bare weld cable
(use two on small diameter cable),
and insert into connector body.
4 Setscrew
Tighten setscrew against copper
strip.
5 Handle
6 Pin
Slide handle over connector body
so holes align; secure by tapping
pin into place.
Tools Needed:
7/32 in
1 2
3
4
5
6
1 in
(26 mm)