Marantz DV8300 - Manual (Page 16)

Getting Started 4
16
Using the FL menu
The FL menu has been designed to set
“DISP MODE”, “AUTO P OFF” and
“REMOT CODE”.
The FL menu can not be used if a disc is
playing.
It is recommended to set the FL menu
before loading a DVD.
If a DVD has been loaded, be sure to press
STOP
7 twice before proceeding.
(If “RESUME” is displayed in the FL display,
press STOP
7.)
Selecting the FL menu
Press SETUP for longer than 1 sec.
The FL OFF indicator on the player turn on and
off.
FL menu is displayed in the FL display.
Move the cursor control joystick down to select
the FL menu you want as follows.
(Example)
PLAY
FL OFF
STANDBY
ON/OFF POWER
SACD/DVD PLAYER DV8300
OPEN/CLOSE
STOP PAUSE
DISP MODE
FL OFF
FL menu
DISP MODE
AUTO P OFF
REMOT CODE
To exit the FL menu
When you have compleated setting up the FL
menu or if you want exit the FL menu. Press
SETUP to close the FL menu.
DISP MODE setting
Select DISP MODE, then press ENTER.
Move the cursor control joystick down to select
the type of DISP MODE you want to set as
follows.
DISP OFF
DISP ON
* Factory setting
*
Press ENTER you want to set.
The menu select is set.
• If you replay a CD or SACD while DISP ON is
selected, FL display and video output shut off
automatically. FL display and video output are
on during Stop and Pause. And if you push the
Dimmer Button on the remote control during
DISP ON, for three seconds, only FL display is
displayed.
AUTO P OFF setting
Select AUTO P OFF, then press ENTER.
Move the cursor control joystick down to select
the type of AUTO P OFF you want to set as
follows.
(Example)
ON 30 MIN
OFF
* Factory setting
*
Press ENTER you want to set.
The menu select is set.
• The DVD player support two remote control
codes: DVD 1 and DVD 2.
• Set the remote control code of the Remote
Control to the same setting.
• See page 14 for more information.
DVD 1
DVD 2
* Factory setting
*
Press ENTER you want to set.
The menu select is set.
• The standby mode is automatically selected to
save power if the player is left in the stop mode
for about 30 minutes.
REMOT CODE setting
Select REMOT CODE, then press ENTER.
Move the cursor control joystick down to select
the type of REMOT CODE you want to set as
follows.
(Example)
(Example)