Marantz DV8300 - Manual (Page 28)

Playing Discs 5
28
6 Press ENTER or
3 to start playback immedi-
ately, or PROGRAM to exit if you want to start
playback later.
During program play, you may occasionally see the
start of a chapter that was not programmed when the
chapter number changes. This is not a malfunction.
Note
You can’t program track numbers over 100 on SACDs.
For Video CDs that feature PBC, make sure that
the disc is stopped before you start.
1 Press PROGRAM.
Exit Move Play
Current: Track
Total Time
1(/10)
0.00
Program Track
PROGRAM ENTER
2 Enter the track numbers for your program list.
For tracks 1–9, use the corresponding number
buttons. For 10 and over, use the +10 button (+10,
+10, 4 for 24, etc.)
• You can program a pause instead of a track/chapter:
press 8 instead of entering a number in the program
list. (A pause can't be the first or last step in the
list.)
• A program list can contain up to 24 steps.
3 Press ENTER or
3 to start playback immedi-
ately, or PROGRAM to exit if you want to start
playback later.
• You can't start playback later with a PBC Super
VCD/Video CD; press ENTER or
3 to start.
Programming tips
• To view the program list press PROGRAM.
• To delete a step in the program list, position
the cursor on the title/group/chapter/track
and press CLEAR.
• To insert a step into the program list, position
the cursor where you want the new step to
appear, then enter the title/group/chapter/
track number.
All the following steps move up one.
• To add the currently playing title/group/
chapter/track to the program list, press and
hold PROGRAM for about a second.
If there is no current program list, a new one is
created (for DVD, if the last list created was a title
list then the a title program list is created, otherwise
a chapter program list is created).
• To delete the program list, stop playback
(press
7), then press CLEAR.
The program list is also erased when you remove the
disc from the player or turn the power off
(
standby ).
• To delete a memorized DVD program list, load
the DVD, press PROGRAM, then change the
Program Memory option to Off. Press ENTER
to confirm.