Milan Technology MIL-SM8002TG - Manual (Page 21)

13
CLI Management
The system supports two types of console management – CLI command and Menu
selection. After you login to the system, you will see a command prompt. To enter CLI
management interface, enter “ enable” command. The following table lists the CLI
commands and description.
Commands Level
Modes Access Method Prompt Exit Method About This Mode1
User EXEC
Begin a session with
your switch.
switch>
Enter logout or
quit.
The user commands available at
the user level are a subset of
those available at the privileged
level.
Use this mode to
• Perform basic tests.
• Display system information.
Privileged
EXEC
Enter the enable
command while in
user EXEC mode.
switch#
Enter disable to
exit.
The privileged command is
advance mode
Privileged this mode to
• Display advance function status
• Save configures
Global Configuration
Enter the configure
command while in
privileged EXEC
mode.
switch (config)#
To exit to
privileged EXEC
mode, enter exit
or end
Use this mode to configure
parameters that apply to your
switch as a whole.
VLAN database
Enter the vlan
database command
while in privileged
EXEC mode.
switch (vlan)#
To exit to user
EXEC mode,
enter exit.
Use this mode to configure
VLAN-specific parameters.
Interface
configuration
Enter the interface
command (with a
specific interface)
while in global
switch
(config-if)#
To exit to global
configuration
mode, enter exit.
To exist to
Use this mode to configure
parameters for the switch and
Ethernet ports.