Milan Technology MIL-SM8002TG - Manual (Page 26)

18
flowcontrol on or no
flowcontrol
Interface
configuration mode
Use the flow control
configuration command on
Ethernet ports to control traffic
rates during congestion.
Use the no form of this
command to disable security on
the port.
On
Switch (config)# interface
fastEthernet 0/1
Switch (config-if)# flowcontrol
on
security on or no
security
Interface
configuration mode
Use the security configuration
command on Ethernet ports.
Use the no form of this
command to disable security on
the port.
Disable
Switch (config)# interface
fastEthernet 0/1
Switch (config-if)# security
on
priority on [hi | low] or
no priority
Interface
configuration mode
Use the priority configuration
command on Ethernet ports.
Use the no form of this
command to disable security on
the port.
Disable
Switch (config)# interface
fastEthernet 0/1
Switch (config-if)# priority on
hi
Bandwidth [in | out]
[value]
Interface
configuration mode
Set bandwidth in or out rate.
The value rage is (0~999), and
zero of the value is disable
(The module can’t be setting)
Disable
Switch (config)# interface
fastEthernet 0/1
Switch (config-if)# bandwidth
in 50