Milan Technology MIL-SM8002TG - Manual (Page 28)

20
show bandwidth
Interface
configuration mode
Display the bandwidth of the
values
Switch (config)# interface
fastEthernet 0/1
Switch (config-if)# Show
bandwidth
Trunk Commands Set
Commands Command Level Description Defaults Example
port group
[group-number]
[port-list] lacp [on | off]
workp [work ports]
no port group
[group-number] lacp [on
| off] workp [work ports]
Global
configuration mode
Add trunking group.
Use the no form of this
command to delete trunking
group.
Disable
LACP:
Switch (config)# port group 1
1-4
lacp on workp 2
Trunk without LACP:
Switch (config)# port group 1
1-4
lacp off workp 4
show group [group-ID]
Privileged EXEC
mode
Display trunk group
information. If there is no
group-number in put,
display all trunk groups.
Switch # show group 1
Group Trunk.1:
Ports: 02 03 04
Priority: 0001
Lacp: Enable
Work ports: 0
port group
[group-number]
activityport [port-list]
Global
configuration mode
Set trunking group port
active
Switch (config)# port group 3
activityport 2-4
Trunk.1 Lacp: Enable