Motorola SSETM 5000 - Manual (Page 91)

6881094C12-A November 11, 2004
Disassembly/Reassembly Procedures: Disassembly/Reassembly Procedures for Accessories 7-9
7.4.4 Carry Case
This section explains how to assemble the carry case, belt loop and T-strap.
1. Slide the belt loop onto your belt.
2. Snap the two horizontal snaps of the T-strap onto the back of the carry case so that the cords
lead upwards.
3. Insert the radio snugly into the carry case.
4. Pull the cords of the T-strap over the top of the radio, on either side of the Channel Select
knob.
5. Snap the other end of the T-strap onto the front of the carry case.
6. Turn the carry case, with the radio strapped in, upside down.
7. Align the knob on the back of the carry case with the open end of the groove on the front of
the belt loop.
8. Slide the carry case all the way down into the groove.
9. Turn the carry case and radio right side up.
Figure 7-6. Assembling the Carry Case
7
5
5
3 1
1