Muratec F-160 - Manual (Page 15)

1.8
Getting started
Attaching the parts
1 Attach the document
tray by inserting it
into the appropriate
holes, as shown.
2 Attach the paper hopper into the
appropriate hole, as shown. Press
gently until the hopper won’t go
in any farther.
3 Attach the document hopper by
inserting its two pegs at a
slightly upward angle into the
appropriate holes, as shown.
Plug in and power up
1 Plug one end of the telephone line
cord into the
LINE jack on the back of
the machine. Plug the other end of
the cord into a standard telephone
wall jack, just as you would plug in a
phone.
Note: If you purchased an optional
handset, don’t confuse its curled handset cord with the uncurled tele-
phone line cord.
2 Plug the non-pronged end of the AC power cord
into the AC power cord jack on the left side of the
machine.
3 Plug the pronged end of the AC power cord into
a 230 VAC electrical outlet (use a surge suppresser, as mentioned on page 1.6).
4 Use the AC power switch on the front of
the machine to turn it on. The markings
are international standards: I means on,
O means off.
Setting the paper size for the multipurpose tray
The multipurpose tray can hold A 4-sized paper for your machine. All you have to do
is tell the machine that you are using A 4-sized paper.
Important: If you use a different size from the size you set here, the machine
won’t print. Be sure to change this setting whenever you load a
different paper size.
Note: If you have the option module WP-300, you can use other papers than A 4-
sized paper. (Refer to optional WP-300 operating instructions for the
procedure of setting the paper size.)
1 Press / PROGRAM , J , 0, 4, ENTER . The LCD shows the tray’s current setting:
2 Press ENTER to save the setting.
Adjusting the monitor speaker’s volume
To adjust the volume of the monitor speaker:
1 Press MONITOR / CALL on the control panel. You should hear a dial tone, and the
display shows:
Important: If you don’t hear a dial tone, make sure your fax machine is
plugged into a working phone line.
** Tel Mode **
_
Paper Size: A4
Program/Enter
Paper hopper
Document
hopper