Muratec F-160 - Manual (Page 37)

Beyond the Basics
Setting the transmission confirmation stamp
You can set your fax machine so that it will automatically place a small stamp mark
on the front of each original document that it successfully scans.
Important: Turn off this feature if you’re sending documents you don’t want the
fax to stamp.
1 Press / PROGRAM , J , 1, 9, ENTER . The LCD shows your fax’s current setting:
2 Press or / PROGRAM until the mode you want appears.
In this example, we’ve chosen On.
3 Press ENTER to save the setting.
Language settings
English is the language your machine initially displays on the LCD and uses to print
reports. But you can set it to “speak” French, Spanish or German, too.
As you give the order for the machine to change languages, it “rolls” from English to
French to Spanish to German, and then back to English.
To make the change from one language to the next, press /
PROGRAM , #.
Checking the language
If, after making a language change, you’re not sure which language is showing,
press /
PROGRAM once and decide based on what you see on the LCD :
is French.
is Spanish.
is German.
If the language you see is the one you want, press STOP to return to standby mode.
If you want to change languages, press STOP to return to standby mode.
Then press / PROGRAM , # again to go to the next language in the cycle.
Printing your settings
After you’ve programmed settings into your machine, print a settings list. We
recommend this, particularly if you’re sharing the machine with other users, who
might change the settings.
With this list, you can quickly confirm that all of your settings are correct, without
having to go back and check them on the machine. Or, if you do need to undo
someone else’s changes, this list guides you in returning the machine to your
preferred settings.
Note: Please refer to the index at the end of these instructions to locate any
settings you don’t recognise or understand.
To print the settings list:
1 Press / PROGRAM , I , ENTER .
2 Press ENTER until the LCD shows:
3 Press ENTER to print the settings list.
Print Setting List
Enter/Stop
Enter Time
’99 09/11 20:30
A Zielwahl
Programm/Eing.
A Núm. Una-Tecla
Program./Sel.
A Num. Une-Touche
Program./Val.
Stamp: On
Program/Enter
Stamp: Off
Program/Enter
2.6