Miller Electric Maxstar 200 STR - Manual (Page 16)

OM-2233 Page 10
Warning! Watch Out! There are
possible hazards as shown by the
symbols.
1
Electric shock from wiring can
kill.
2 Disconnect input plug or
power before working on
machine.
3 Hazardous voltage remains
on input capacitors after
power is turned off. Do not
touch fully charged
capacitors.
4 Always wait 60 seconds after
power is turned off before
working on unit, OR
5 Check input capacitor voltage,
and be sure it is near 0 before
touching any parts.
6 When power is applied failed
parts can explode or cause
other parts to explode.
7 Flying pieces of parts can
cause injury. Always wear a
face shield when servicing
unit.
8 Always wear long sleeves and
button your collar when
servicing unit.
9 After taking proper
precautions as shown,
connect power to unit.
S-185 836
> 60 s
V
V
V
1 2 3 4 5
6 7 8 9
S-179 309-A
∠ = <60 °
∠
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Falling equipment can cause
injury and damage to unit.
3 Always lift and support unit
using both handles. Keep
angle of lifting device less
than 60 degrees.
4 Use a proper cart to move
unit.
5 Do not use one handle to lift
or support unit.
1/96
1
2 3 4 5
3-2. WEEE Label (For Products Sold Within The EU)
Do not discard product (where ap-
plicable) with general waste.
Reuse or recycle Waste Electrical
and Electronic Equipment (WEEE)
by disposing at a designated collec-
tion facility.
Contact your local recycling office
or your local distributor for further
information.