Integra DTR-5.8 - Manual (Page 68)

68
Advanced Setup
Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 41).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Speaker Settings
See “Speaker Settings” on page 51.
Speaker Configuration
With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.
The following crossover frequencies can be specified:
Full Band, 40 Hz, 45 Hz, 50 Hz, 55 Hz, 60 Hz, 70 Hz,
80 Hz, 90 Hz, 100 Hz, 120 Hz, 130 Hz, 150 Hz, or
200 Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the
speaker. Refer to your speaker’s manuals to determine
the optimum crossover frequencies.
Speaker Setup
This setting is set automatically by the Automatic
Speaker Setup function (see page 41).
2-11
2, 3
1
1, 12
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Config,” and then press [Enter].
The Speaker Config menu appears.
4 Use the Up and Down [ ]/[ ]
buttons to select “Subwoofer,”
and then use the Left and Right
[
]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
5 Use the Up and Down [ ]/[ ]
buttons to select “Front,” and
then use the Left and Right [
]/
[ ] buttons to select a crossover
frequency.
Note:
If the Subwoofer setting in step 4 is set
to No, this setting is fixed at Full Band.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
2–2. Speaker Config
Subwoofer Yes
Front 100Hz
Center 100Hz
Surround 100Hz
Surr Back
100Hz
Surr Back Ch 2ch
LPF of LFE 120Hz
Double Bass Off