Integra DTR-5.8 - Manual (Page 78)

78
Advanced Setup—Continued
Correcting Sound and Picture Sync
When using progressive scanning on your DVD player,
you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the
audio signals. You can set it from 0 to 100 milliseconds
(msec) in 2 millisecond steps.
Note:
• This setting is not available when the Direct listening
mode is used with an analog input signal.
• This procedure can also be performed on the remote
controller by using Input Selector buttons and [Enter]
button.
Press and hold, for more than 5 seconds, the input
selector button for the input source that you want to
correct. Use the Left and Right [
]/[ ] buttons to
adjust the delay.
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “4. Source
Setup,” and then press [Enter].
The Source Setup menu appears.
3 Use the Input Selector buttons on
the remote controller to select
the input source that you want to
correct.
This can be the [DVD], [VCR/DVR],
[CBL/SAT], [Game/TV], [AUX],
[Tape], [Tuner], or [CD] input source.
4 Use the Up and Down [ ]/[ ]
buttons to select “2. A/V Sync,”
and then press [Enter].
The A/V Sync menu appears.
If HDMI Lip Sync is enabled (see
page 82), and your TV or display sup-
ports HDMI Lip Sync, the HDMI Lip
Sync delay time is displayed under-
neath in parentheses.
4. Source Setup
1. IntelliVolume
2. A/V Sync
DVD
4–2. A/V Sync
A/V Sync 20msec
(HDMI Lip Sync 0msec)
Press Enter to see picture.
DVD
5 Press [Enter], and use the Left
and Right [
]/[ ] buttons to
adjust the delay from 0 to 100 mil-
liseconds in 2 millisecond steps.
To view the TV picture while setting
the delay, press [Enter].