Advanced setup —continued – Integra DTR-5.8 User Manual
Page 72
72
Advanced Setup—Continued
Equalizer Setting
Here you can adjust the EQ of individual speakers. To set
the volume of individual speakers see page 71.
1
Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
]/[
]
buttons to select “2. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
This setting is set automatically by the Automatic
Speaker Setup function (see page 41).
1, 8
2-7
2, 3
1
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
3
Use the Up and Down [
]/[
]
buttons to select “5. Equalizer
Settings,” and then press [Enter].
The Equalizer Settings menu appears.
4
Use the Left and Right [
]/[
]
buttons to select:
Off: Tone off, response flat.
Audyssey: The tone for each speaker
is set automatically by the
Automatic Speaker Setup
function.
Be sure to select this set-
ting after having per-
formed the Automatic
Speaker Setup.
Manual: You can adjust the EQ of
each speaker manually.
If you select Manual, continue with this
procedure. If you select Off or Audys-
sey, go to step 8.
5
Use the Down [
] button to
select “Channel,” and then use
the Left and Right [
]/[
] but-
tons to select a speaker.
6
Use the Up and Down [
]/[
]
buttons to select a frequency,
and then use the Left and Right
[
]/[
] buttons to adjust the
level at that frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8000 Hz) affect treble sounds.
2–5. Equalizer Settings
Equalizer Off
2–5. Equalizer Settings
Equalizer Manual
Channel Front
80Hz
0dB
250Hz
0dB
800Hz
0dB
2500Hz
0dB
8000Hz
0dB