Integra DTR-5.8 - Manual (Page 91)

91
Controlling Other Components—Continued
Integra components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra component by pointing
the remote controller directly at it, or you want to control
an Integra component that’s not connected via
, use
the following remote control codes:
[DVD] Remote Mode button
0627: Integra DVD player without (default)
[CD/MD/CDR/Dock] Remote Mode button
1817: Integra CD player without (default)
0868: Integra MD recorder without
1323: Integra CD recorder without
2990: Onkyo RI Dock without
Note:
If you connect an
-capable Integra MD recorder, CD
recorder, or Onkyo RI Dock to the TAPE IN/OUT or
GAME/TV jacks, for remote operation to work properly,
you must set the input display to MD, CDR, or DOCK
(see page 51).
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Integra
Components Connected via
1 Make sure the Integra component is con-
nected with an
cable and an analog
audio cable (RCA).
See page 39 for details.
2 Enter the appropriate remote control code
for the [DVD] or [CD] Remote Mode but-
ton.
[DVD] Remote Mode button
1612: Integra DVD player with
[CD/MD/CDR/Dock] Remote Mode button
1327: Integra CD player with
1808: Integra MD recorder with
1322: Integra CD recorder with
1993: Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3 Press the [DVD] or [CD] Remote Mode but-
ton, point the remote controller at the AV
receiver, and operate the component.
Resetting Remote Mode Buttons
1 While holding down the Remote
Mode button that you want to
reset, press the [L Night] button
for 3 seconds.
The Remote Mode button lights up.
2 Press the Remote Mode button
again.
The Remote Mode button flashes
twice, indicating that it’s been reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra DVD players and CD players
respectively. When these buttons are
reset, the preprogrammed code is
restored.
Resetting the Remote Controller
1 While holding down the
[Receiver] Remote Mode button,
press the [L Night] button for 3
seconds.
The [Receiver] button lights up.
2 Press the [Receiver] Remote
Mode button again.
The [Receiver] button flashes twice,
indicating that it’s been reset.