IBM 440 - Manual (Page 162)

148 IBM ^ xSeries 440 Planning and Installation Guide
Figure 5-19 Stop adapter use by the operating system
3. Select the adapter you want to stop and click Stop.
4. Confirm that you want to stop the device by clicking OK.
5. Once the operating system confirms the adapter has been stopped, use the
Slot Blink action (see step 6 on page 139) to indicate which adapter to
remove.
6. Remove the adapter.
7. Active PCI Manager then shows the adapter has been removed, as shown in
Figure 5-20 on page 149, by adding an to the bottom of the graphic and
changing the LED error status to “Hot eject successful”.