IBM J.D. EDWARDS' ONEWORLD B73.3 - Manual (Page 97)

Using ServerGuide for IBM Netfinity 85
At this point, ensure that you have the retail version of Windows NT Server 4.0
available. Click on the > button to proceed with the installation.
7. The Installed Adapters screen is displayed. This screen shows the server
type, the hard disk adapters and controllers, and the network adapters and
controllers installed in the server, as detected by the ServerGuide. Click on the
> button to continue with the installation.
8. Select FAT as the type of partition to be created. Make your Windows NT
Server partition size 2 GB. Click the > button to proceed with the installation.
9. Select 5 concurrent connections (or whatever the correct number of
connections should be entered). Click the > button twice to proceed with the
installation.
10.Remove the SoftwareGuide CD from the CD-ROM drive and insert the
Windows NT Server 4.0 CD. Click OK to continue with the installation of
Windows NT Server 4.0.
11.After the files are copied to your server, you will see a dialog box indicating to
remove the Windows NT Server 4.0 CD from the drive. Click OK to continue.
Your system will begin to restart.
6.3.2 Operating System FixPaks CD-ROM
This CD-ROM contains the vendors’ FixPaks for their operating systems. FixPaks
are provided for Microsoft Windows NT, Novell IntranetWare, and OS/2 Warp.
Use this CD-ROM to load the Microsoft Windows NT Server 4.0 Service Pack 4.
Remember to check your Microsoft Web site for recent releases of service packs.
The Web site is
http://www.microsoft.com/ .
Use the following notes for a successful installation of your Deployment server
and Enterprise server.
1. Refer to your Windows NT Server documentation for setup and
configuration instructions.
2. When your server reboots, if you see a Virus Warning Screen, ensure the
highlighted line states Change is expected and press Enter.
3. Although the setup Microsoft Internet Information Server is a requirement
for the Deployment server, do not select it during the Windows NT Server
4.0 installation.
4. During our installation, we selected TCP/IP and NetBIOS as our protocols.
5. A MSDOS window will appear running setup.exe, press Enter twice to
continue.
6. Create your repair disk.
7. Once your Windows NT Server 4.0 is up and running, remember to partition,
format and assign drive letters for the remaining hard drive(s).
Notes