IBM 2196 - Manual (Page 125)

Adding and replacing system board components 9-11
Replacing the system battery
Follow these steps to replace the battery:
1. Place the blade of a small, flat-blade screwdriver under the edge of the
retaining clip.
2. Turn the screwdriver one quarter turn, raising the clip while pressing down on
the old battery to remove it.
3. Carefully raise the retaining clip, and insert the new battery with the + symbol
facing out.
4. Insert a new 3V lithium battery (CR2032) into the socket and press it down
until the securing clip clicks and locks the battery in if you replace the system
battery, you need to reset the system date and time in Setup.I
Note:
Before replacing the lithium battery review the
lithium battery notice on page xii.
Important:
Make sure you insert the battery with the
positive side on top. A plus (+) sign indicates
the positive side.