IBM 2196 - Manual (Page 79)

6-8 IBM Personal Computer User Guide
Canceling changes
You might make changes to the Setup parameter that you do not want to keep.
To cancel the changes that you have made, follow these steps:
1. Return to the Configuration/Setup Utility menu
2. Highlight the Exit Without Saving option then press Enter and Y . Then press
Enter again.
The Setup program then clears all the changes that you made and resets the
parameters to the previous settings. These settings are the settings that were
in place when you started Setup.
Exiting Setup
When you have finished viewing the settings and making changes, press Esc to
return to the Configuration/Setup Utility menu. From this location, you can exit Setup
and save your changes or exit without saving your changes.
To exit Setup without saving the changes, follow these steps:
1. From the Configuration/Setup Utility menu, press the Esc key.
2. A dialog box appears saying "Quit without Saving (Y/N)? ” Type Y , and then
press Enter .
To exit setup and save the changes, follow these steps:
1. From the Configuration/Setup Utility menu, select Save and Exit Setup .
Then, press Enter .
2. A dialog box appears saying "Save to CMOS and EXIT (Y/N)? ” Type Y , and
then press Enter . The computer restarts using the new settings.
Note:
You also can Exit the Setup by highlighting the Save &
Exit Setup option or Exit without Saving option and
follow the dialog box directions.