IntraServer Technology ITI-90-100250 - Manual (Page 32)

Page 32 of 83
Hard Disk Activity Light
IntraServer’s ITI-8000 Series adapters have a built in activity LED, which
indicates when the SCSI bus is busy. The LED will flash to indicate activity
on the bus.
Connecting External SCSI
Devices
Optional cables are available from IntraServer for all external devices. See
the cable selection Table 5 in this guide to determine the correct cable for
your application. You will need to know the type of connector you require
on each end of the cable, and the length of cable required.
Apply the same rules for ID and termination as for internal devices:
•
Only the end device on the bus (last device on the cable) should
have termination enabled
•
Each device must have a unique SCSI ID
All IntraServer ITI-8000 Series modules will automatically enable or disable
SCSI termination by sensing the cable configuration.
NOTE: If you are using external devices, the end of the external cable
MUST be correctly terminated with an LVD Ultra2 terminator.