IntraServer Technology ITI-90-100250 - Manual (Page 64)

Page 64 of 83
Troubleshooting
The following are some potential error messages that may be preceded by a
warning message displayed by the operating system. In the message
descriptions below; the ITHPS<n> (or ITSPS(n) in case of the ITSPS driver)
signifies that <n> can be replaced by some number assigned to it by the
operating system. That value helps to identify the SCSI bus that is reporting
the error.
ITHPS<n>: This hardware not supported by this driver
ITHPS has been told to control a 53C896 (53C895 for ITSPS)
hardware which is made by a manufacturer other than IntraServer
Technology. This adapter requires a special driver provided by that
manufacturer. Please contact the manufacturer for assistance.
ITHPS<n>: Failed to map device registers
ITHPS was unable to access the hardware registers necessary for
operation. The operating system did not properly configure the PCI
device.
ITHPS<n>: Hardware not properly enabled by system, cmd=xxxxh
The system has not properly enabled the configuration resources
that ITHPS needs in order to use this hardware. The cmd=xxxxh
value needs to be reported to technical support.
ITHPS<n>: Ignored invalid scsi-initiator-id value = x
The ithps.conf file has an invalid scsi-initiator-id value as displayed
in the error message. The allowable values are in the range 0..15.
ITHPS<n>: Could not allocate memory to read configuration data.
The driver was unable to allocate memory required to process the
configuration data. This means that the configuration was not
properly determined. To fix this you may need to manually
configure the driver using the ithps.conf file.
ITHPS<n>: Unable to make reset notification callbacks
The ITHPS was unable to notify the target device driver of a SCSI
bus reset. The target driver may start to malfunction because of
this.
ITHPS<n>: ddi_dma_numwin() failed
ITHPS<n>: ddi_dma_getwin() failed
ITHPS<n>: ddi_dma_alloc_handle: xxh unknown/impossible