IntraServer Technology ITI-90-100250 - Manual (Page 76)

Page 76 of 83
List of Figures
Figure 1: ITI-8241C-S I/O Connector Configuration....................................15
Figure 2: ITI-8241C-R Rear I/O Connector Configuration...........................16
Figure 3: ITI-8241C-S Configuration Jumper and Header Location............17
Figure 4: IntraServer ITI-8241C-R Rear I/O Transition Module..................19
Figure 5: Video Configured for Front I/O .....................................................21
Figure 6: Video Configured for Rear I/O.......................................................21
Figure 7: Ethernet Configured for Front I/O .................................................22
Figure 8: Ethernet Configured for Rear I/O ..................................................22
Figure 9: Internal Ultra2/LVD Devices Using ITI-8241C-R Rear I/O..........34
Figure 10: External Ultra2/LVD Devices ......................................................35
Figure 11: Dual Rear SCSI Cabling in Side-by-Side Layout - one disk per
node using SCA adapter .............................................................36
Figure 12: Dual Rear SCSI Cabling in Side-by-Side Layout - two disks per
node using SCA adapter .............................................................37
Figure 13: Dual Rear SCSI Cabling in Side-by-Side Layout - one disk per
node using internal SCSI cable with terminator ........................38
Figure 14: Dual Rear SCSI Cabling in Side-by-Side Layout - two disks per
node using internal SCSI cable with terminator ........................39
Figure 15: Video Connector...........................................................................70
Figure 16: 8-Pin MJ Connector (Front) ........................................................71
Figure 17: ITI-8241C-S Block Diagram.......................................................73
List of Tables
Table 1: Hardware Covered by this Guide ....................................................10
Table 2: Available Options.............................................................................10
Table 3: Operating System Support................................................................11
Table 4: Configuration Headers and Jumpers...............................................18
Table 5: ITI-8000 Series SCSI Cable Selection Guide...................................28
Table 6: SUNCluster™ Cabling and Termination Details ............................40
Table 7: Hardware and Software Requirements ............................................42
Table 8: Glossary of Terms............................................................................69
Table 9: Video Connector Pinout...................................................................70
Table 10: 8-Pin MJ Connector Pin Assignments ...........................................71
Table 11: Adapter to Network Hub Wiring....................................................72
Table 12: Adapter to Adapter (point to point) Wiring....................................72
Table 13: Backplane Connector J3 Pin-out ...................................................74
Table 14: Backplane Connector J5 Pin-out ...................................................75