IntraServer Technology ITI-90-100250 - Manual (Page 51)

Page 51 of 83
Identifying the SCSI disks
The probe-scsi-all command is used to identify the SCSI devices on your
IntraServer adapter.
ok probe-scsi-all
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1
Target 0
Unit 0 Disk SEAGATE ST39102LC 0004
Target 1
Unit 0 Disk SEAGATE ST39102LC 0004
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0
Target 0
Unit 0 Disk IBM DDRS-34560D DC1B
Target 1
Unit 0 Disk IBM DDRS-34560D DC1B
If the SCSI disks on your IntraServer adapter are not identified by your
system, check the following:
1. Does each disk have a unique SCSI ID?
2. Does each disk have an ID that does not conflict with the ID of the
IntraServer adapter (Default id = 7)?
3. Is the bus correctly terminated? The IntraServer adapter will
automatically terminate the host end of the bus. You must have an
SE/LVD terminator at the end of the SCSI chain.