Software installation – IntraServer Technology ITI-90-100250 User Manual
Page 48
Page 48 of 83
________________________6
Software Installation
Custom, high performance, Ultra2 SCSI device drivers for Sun Solaris
SPARC™ based platforms, including Versions 2.6 and 7.0 are available from
IntraServer, and are included with your adapter.
Detailed instructions for software installation for Sun Solaris are included in
this section.
The Ethernet ports on the card are supported under the qfe Ethernet driver,
which is resident on the Solaris 2.6 and later software distribution media.
The video section of the card is based on ATI’s RAGE IIC, and is supported
under the m64 driver on the Solaris 2.6 and later software distribution media.
NOTE:
It is highly recommended that you make a backup of your system
disk before installing any software. Failure to back up all files on
your system may result in unrecoverable loss of data.
Installation for Sun™ SPARC™
Solaris™ Ultra2 SCSI Options
(ITI-8200 Series)
IntraServer’s ITI-8000 Series adapters offer the highest possible performance
on Sun™ Solaris™ systems. IntraServer’s Ultra2 SCSI drivers, (ITSPS and
ITHPS) are optimized for low CPU overhead and high I/O throughput,
making use of IntraServer’s single interrupt scripts.
IntraServer’s Ultra2 SCSI adapters have built in Fcode, designed to operate
in Sun’s OpenBoot environment, allowing Ultra2 SCSI devices to be
available to the OpenBoot (ok) prompt.
This chapter describes the features and use of the IntraServer Device Drivers
for the Solaris Operating system 2.6 and 7.0