Removing/installing the seat post, Removing, Installing – Invacare HMV Highly 300 User Manual

Page 35

Advertising
background image

SECTION 7—SEAT

Part No. 1118395

35

300 and 400

REMOVING/INSTALLING THE SEAT POST

ƽ WARNING

Ensure that the seat post mounting screw is properly engaged and locked. Other-

wise, injury and/or damage may result.

NOTE: Take note of position and orientation of the seat post and seat post mounting screw before

removing.
NOTE: The seat post has three (3) height settings. If a change in seat height is desired refer to

adjusting seat height in this section of the manual.
NOTE: For this procedure, refer to FIGURE 7.2.

REMOVING

1. If necessary, remove the seat. Refer to Removing/Installing the Seat on page 34.
2. Remove the mounting screw, two (2) washers and locknut securing the seat post to the

frame post (FIGURE 7.2).

3. Lift seat post UP and remove from frame post.

INSTALLING

1. Insert the seat post into the frame post and align the frame post mounting hole with

the desired seat post mounting hole. Refer to FIGURE 7.2.

2. Insert mounting screw through both the frame post and the seat post. Install the two

(2) washers and locknut onto mounting screw and securely tighten.

3. If necessary, install the seat. Refer to Removing/Installing the Seat on page 34.

FIGURE 7.2 - REMOVING/INSTALLING THE SEAT POST

Seat Post

Seat Post

Mounting Holes

Washer

Washer

Locknut

Mounting Screw

Frame Post

Mounting Screw

NOTE: Seat post on 300 shown. Seat post on

400 installs the same way.

Advertising
This manual is related to the following products: