To figure 12.2, Detail “b” of figure 12.2), Der (detail “b” of figure 12.2) – Invacare HMV Highly 300 User Manual
Page 52: A” of figure 12.2, Figure 12.2)
SECTION 12—BATTERIES
52
7. Connect the RED and BLACK battery connector to the wiring harness assembly.
Tighten securely.
8. Secure batteries in the battery tray using the battery strap (Detail “A” of FIGURE 12.2).
9. Reinstall the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
10. Reinstall the seat. Refer to Removing/Installing the Seat on page 34.
NOTE: New batteries MUST be fully charged BEFORE using, otherwise the life of the batteries
will be reduced.
11. If necessary, charge the batteries. Refer to Charging the Batteries on page 58.
FIGURE 12.2 - REMOVING/INSTALLING THE BATTERIES ON 300
DETAIL “A” - REMOVING/INSTALLING THE BATTERIES
DETAIL “B” - BATTERY WIRING HARNESS
Battery
Strap
Battery
Tray
Batteries
Installed
NOTE: Seat and Rear Shroud not shown for clarity.
Battery Tray
Batteries
Removed
RIGHT
BATTERY
LEFT
BATTERY
POSITIVE (+) RED
Battery Cable
50Amp Fuse
POSITIVE (+) RED
Battery Terminal
NEGATIVE (-) BLACK
Battery Terminal
POSITIVE (+) RED
Battery Terminal
NEGATIVE (-) BLACK
Battery Terminal
NEGATIVE (-) BLACK
Battery Cable
WHITE Battery
Cable (Jumper)
RED and BLACK
Battery Connector