Invacare HMV Highly 300 - Manual (Page 47)

SECTION 11—WHEELS AND CASTERS
Part No. 1118395 47 300 and 400
REMOVING/INSTALLING THE FRONT WHEEL
NOTE: Take note of position and orientation of wheel and mounting hardware before removing.
NOTE: For this procedure, refer to FIGURE 11.2.
REMOVING
1. Turn power OFF and remove the key from the ignition.
2. Place the FRONT of the powered scooter UP on blocks so that the FRONT wheel is off
the ground.
3. Remove the mounting screw, locknut and two (2) spacers that secure the FRONT
wheel to the fork.
4. Remove FRONT wheel from fork.
FIGURE 11.2 - REMOVING/INSTALLING THE FRONT WHEEL
INSTALLING
ƽ WARNING
Front wheel MUST be mounted in the correct fork mounting holes (upper mount-
ing holes for the 400 and lower mounting holes for 300) - otherwise injury may
result.
1. Perform one (1) of the following -
A. On 300 - Align front wheel with the lower fork mounting holes.
B. On 400 - Align front wheel with the upper fork mounting holes.
2. Using the mounting screw, locknut and two (2) spacers that secure the front wheel to
the fork
3. Securely tighten front wheel mounting hardware.
Lower Fork Mounting
Hole for 300
Spacer
Locknut
Fork
Mounting Screw
Spacer
Upper Fork Mounting
Hole for 400
Front Wheel