Invacare HMV Highly 300 - Manual (Page 36)

SECTION 7—SEAT
300 and 400 36 Part No. 1118395
ADJUSTING SEAT HEIGHT
NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove the seat. Refer to Removing/Installing the Seat on page 34.
2. Remove the mounting screw, two (2) washers and locknut securing the seat post to the
frame post.
3. Align the frame post mounting hole with one (1) of three (3) seat post mounting holes
to achieve desired seat height (FIGURE 7.2).
4. Insert mounting screw through both the frame tube and the seat post. Install the two
(2) washers and locknut onto mounting screw and securely tighten.
5. Install the seat. Refer to Removing/Installing the Seat on page 34.
ADJUSTING SEAT DEPTH
NOTE: For this procedure, refer to FIGURE 7.3.
ƽ WARNING
DO NOT adjust the seat position outside the specifications recommended by the
manufacturer.
1. Remove the seat from the scooter. Refer to Removing/Installing the Seat on page 34.
2. Remove the adjustable width arms. Refer to Removing/Installing/Adjusting Arms on
page 40.
3. Remove the six (6) mounting screws located under the seat that secure the back
assembly to the seat base.