Intel System Board G4H875-B - Manual (Page 48)

48
2
Hardware Installation
Floppy Disk Drive Connector
The system board is equipped with a shrouded floppy disk drive
connector for connecting a standard floppy disk drive. To prevent
improper floppy cable installation, the shrouded floppy disk
header has a keying mechanism. The 34-pin connector on the
floppy cable can be placed into the header only if pin 1 of the
connector is aligned with pin 1 of the header.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the shrouded
floppy disk header (J21) on the system board and the other end-
most connector to the floppy drive. The colored edge of the
daisy chained ribbon cable should be aligned with pin 1 of J21.
BIOS Setting
Enable or disable this function in the Integrated Peripherals
submenu (“Super I/O Device” section) of the BIOS. Refer to
chapter 3 for more information.
X