Intel System Board G4H875-B - Manual (Page 64)

6 4
3
BIOS Setup
The settings on the screen are for reference only. Your version may not be identical
to this one.
IDE HDD Auto Detection
Detects the parameters of the drive. The parameters will automati-
cally be shown on the screen.
IDE Channel 0 Master/Slave and IDE Channel 1 Master/Slave
The drive type information should be included in the documentation
from your hard disk vendor. If you select ”Auto”, the BIOS will auto-
detect the HDD & CD-ROM drive at the POST stage and show
the IDE for the HDD & CD-ROM drive. If a hard disk has not
been installed, select “None”.
Access Mode
For hard drives larger than 528MB, you would typically select the
LBA type. Certain operating systems require that you select CHS or
Large. Please check your operating system’s manual or Help desk on
which one to select.
IDE Channel 0 Master, IDE Channel 0 Slave, IDE Channel 1 Master and
IDE Channel 1 Slave
Move the cursor to the “IDE Channel 0 Master”, “IDE Channel 0
Slave”, “IDE Channel 1 Master” or “IDE Channel 1 Slave” field, then
press <Enter>.
Note:
The fields in this section will vary in accordance to the settings
in the “On-Chip Serial ATA” field (“OnChip IDE Device” section)
of the Integrated Peripherals submenu.