IBM 1725 SLS - Manual (Page 72)

Emulations
QMS 1725 SLS Print System User's Guide 2-38
Paper Type
Identifies the original image’s paper size.
Pen 1 - Pen 8
Sets the width and color for the eight plotter pens. A width and a color
option are available for each pen.
Notes Setting this option to On partially determines the range of
plotter units for a selected media type. When the plotter
senses the media type, it automatically sets the hard clip
limits to 0.591"/15 mm on three sides and to 1.537"/39 mm on
the fourth side. However, if Expand Mode is set to On, then
the limits are set to 0.197"/5 mm on three sides and 1.143"/29
mm on the fourth side.
The HP-GL emulation senses the media size when the Paper
Type is set to Scale to Paper or when it is set to a particular
media size through the control panel or through a QMS
Document Option Command.
Menu Administration/Emulations/HPGL/Paper Type
Choices Scale to Paper, A (letter/8.5"x11.0"), A4 (210x297 mm), B
(11.0"x17.0"), A3 (297x420 mm)
Default A
Menu Administration/Emulations/HPGL/Pen x /Width
Choices 00-60 (0.1-6.0 mm)
Default Pen 1—7 (0.7 mm)
Pen 2—3 (0.3 mm)
Pen 3—3 (0.3 mm)
Pen 4—3 (0.3 mm)
Pen 5—3 (0.3 mm)
Pen 6—3 (0.3 mm)
Pen 7—3 (0.3 mm)
Pen 8—3 (0.3 mm)
Notes A pen width of 00 defaults the to the pixel setting of 0.1 mm.
Menu Administration/Emulations/HPGL/Pen x /Color