Impex GS-9 - Manual (Page 11)

STEP 5 (See Diagram 5)
A.) Attach the Butterfly Support Frame (#18) to the front of Right Vertical Beam (#21). Attach the
Butterfly Pulley Support (#74) to the back of Right Vertical Beam. Align the holes and secure
them with two M10x2 ½” Carriage Bolts (#17),
∅
¾” Washers (#6), and M10 Aircraft Nuts (#5).
B.) Insert the Axle on the Left Butterfly (#20) through the hole on a Butterfly Adjustment Frame
(#100) into the hole on the Butterfly Support Frame from the bottom. Secure the Left Butterfly,
Butterfly Adjustment Frame, and Butterfly Support Frame together with one
∅
1 ½” Washer
(#16),
∅
1 1/2” Lock Ring (#13), M6 x 1 3/8” Hex Socket Bolt (#12), and M6 Aircraft Nut (#14).
C.) Thread a T-shaped Pull Pin Set (#103) through the hole on Left Butterfly (#20) all the way into
the selected hole on the Butterfly Adjustment Frame (#100) to securely hold the desired Butterfly
exercise position.
D.) Attach the Butterfly Arm Pad (#27) to Left Butterfly (#20). Secure it with two M8 x 2 1/8” Allen
Bolts (#25) and Ø 5/8” Washers (#24).
E.) Repeat the procedure B, C, and D above to install the other side.
F.) Attach a Swivel Pulley Bracket (#72) to the bottom of the Butterfly Pulley Support (#74). Secure
it with a M12 x 4 ½” Allen Bolt (#70), two 7/8” Washers (#71), and one M12 Aircraft Nut (#57).
Repeat for the other side.
10