Impex GS-9 - Manual (Page 8)

STEP 3 (See Diagram 3)
A.) Slide two
∅
2 ½” Rubber Bumpers (#58) onto two Chromed Guide Rods (#22). Insert
the two Guide Rods into the holes on the Right Base Frame (#46). Slide the Selector
Stem (#67) onto the two Guide Rods (#22). Slide the Selector Stem over the Selector
Rod (#69). Secure the Selector Rod to the Selector Stem with two M10 x 1” Allen Bolts
(#56). DO NOT install the plates yet.
B.) Repeat the Procedure A above to install another set of Guide Rods.
C.) Place the Upper Frame (#8) over the two sets of Guide Rods then onto top of Right
Vertical Beam (#21) and Rear Vertical Beam (#50).
D.) Secure each set of Guide Rods (#22) to the Upper Frame with two M10 x 1” Allen Bolts
(#56) and
∅
¾” Washers (#6).
E.) Secure the Right Vertical Beam (#21) to the Upper Frame with one Bracket (#7), two
M10 x 2 ½” Carriage Bolts (#17),
∅
¾” Washers (#6), and M10 Aircraft Nuts (#5).
F.) Attach top of Left Vertical Beam (#77) to the Upper Frame. Attach the bottom of Left
Vertical Beam to the Left Base Frame (#87). Secure the bottom of Left Vertical Beam
with two M10 x 2 ½” Carriage Bolts (#17),
∅
¾” Washers (#6), and M10 Aircraft Nuts
(#5).
G.) Secure the Left Vertical Beam (#77), Rear Vertical Beam (#50), and Upper Frame (#8)
all together with two M10 x 2 ¾” Carriage Bolts (#64),
∅
¾” Washers (#6), and M10
Aircraft Nuts (#5).
H.) Attach the Left Seat Support (#92) to the Left Vertical Beam (#77). Secure it with one
Bracket (#7), two M10 x 2 ½” Carriage Bolts (#17),
∅
¾” Washers (#6), and M10 Aircraft
Nuts (#5). Attach the other end of Left Seat Support (#92) to the Left Base Frame (#87).
Secure it with one M10 x 2 ½” Carriage Bolt (#17),
∅
¾” Washer (#6), and M10 Aircraft
Nut (#5).
I.) Securely tighten all nuts and bolts previously installed.
J.) Carefully tilt the machine on its side. (Help of another person is a MUST.) Secure the
four Guide Rods (#22) to the Right Base Frame (#46) with four M10 x 1” Allen Bolts
(#56) from the bottom.
K.) Attach the bottom of Leg Press Frame (#84) to the bracket on the Left Base Frame
(#87). Secure it with a M12 x 3” Allen Bolt (#89), two
∅
7/8” Washers (#71), and one
M12 Aircraft Nut (#57).
L.) Insert the Seat Incline Adjustment (#90) into the opening on the Left Seat Support (#92).
Use a Lock Knob (#47) to securely hold the desired Seat height.
M.) Insert the Leg Press Plate (#76) into the Leg Press Frame. Use a Lock Knob (#47) to
securely hold the Leg Press Plate in desired position.
7