Impex GS-9 - Manual (Page 25)

STEP 12 (See Diagram 12)
A.) Place a Seat Pad (#29) onto the Right Seat Support (#49). Secure it with two M8 x 2 1/8”
Allen Bolts (#25) and
∅
5/8” Washers (#24).
B.) Attach a Backrest Board (#28) to the Right Vertical Beam (#21). Secure it with two M8 x 2 1/8”
Allen Bolts (#25) and
∅
5/8” Washers (#24).
C.) Insert two Foam Roll Tubes (#36) halfway through the holes on the Right Seat Support (#49)
and Leg Developer (#40). Push four Foam Rolls (#33) onto the Tubes from both sides. Plug
four
∅
1” Round End Caps (#32) into the ends.
D.) Attach the Arm Curl Pad (#34) to the Arm Curl Stand (#35). Secure it with two M8 x 5/8” Allen
Bolts (#31) and
∅
5/8” Washers (#24). Insert the Arm Curl Stand into the opening in front of
the seat. Use the Lock Knob (#47) on the Right Seat Support to obtain the desired position.
E.) Connect the Lat Bar (#2) to the Upper Cable with a C-clip (#4) and a Chain (#3).
F.) Connect the Arm Curl Handle (#44) to the Front Press Cable (#94) with a C-clip (#4) and a
Chain (#3).
24