Impex GS-9 - Manual (Page 21)

STEP 10 (See Leg Press Cable Loop & Diagram 10)
A.) Attach one end of the 97” Leg Press Cable (#96) to the open slot on the back of the Leg
Press Frame (#84). Secure it with one M10 x 1 3/8” Allen Bolt (#75), two
∅
¾” Washers
(#6), and one M10 Aircraft Nut (#5).
B.) Draw the Cable to the front opening on the Left Seat Support (#92). Attach a Pulley to
the opening. Secure it with one M10 x 1 ¾” Allen Bolt (#98), two
∅
¾” Washers (#6),
and one M10 Aircraft Nut (#5).
C.) Draw the Cable around the Pulley then back to the open bracket on the back of the Leg
Press Frame. Install a Pulley as described in Step B above.
D.) Draw the Cable around the Pulley then to the lower opening on the Left Seat Support.
Attach a Pulley to the opening. Secure the Pulley with one M10 x 2 3/8” Allen Bolt (#10),
two Pulley Bushings (#11), and one M10 Aircraft Nut (#5).
E.) Draw the Cable towards back of the machine through the hole on the bottom of the Left
Vertical Beam (#77) to the open bracket on the Left Base Frame (#87).
F.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#98), two
∅
¾”
Washers (#6), one L-shaped Pulley Bracket (#86), and one M10 Aircraft Nut (#5).
G.) Pull the Cable upward and connect to the 298” Vertical Press Cable (#102) with two C-
clips (#4) and one Chain (#3). After completing the steps, adjust the length of this Chain
to adjust the tightness of the Cables.
H.) Draw the Vertical Press Cable to the opening between the Vertical Press Frame (#78).
Attach a Pulley to the opening. Secure it with one M10 x 5 ¾” Allen Bolt (#82), two
∅
¾”
Washers (#6), and one M10 Aircraft Nut (#5).
I.) Draw the Cable around the Pulley and downward to the middle open bracket on the Left
Base Frame. Install a Pulley with a U-shaped Pulley Bracket (#85).
J.) Pull the Cable upward back to the opening on the Vertical Press Frame. Install another
Pulley as described in Step H above.
K.) Draw the Cable downward to the last open bracket on the rear of the Left Base Frame.
Install a Pulley with a U-shaped Pulley Bracket (#85).
L.) Draw the Cable upward to the last open bracket on the Upper Frame (#8). Install
another Pulley. Draw the Cable downward and securely threaded it into the Selector
Rod.
20