IBM Enterprise Server H80 Series - Manual (Page 114)

Required Diagnostic Attributes
The following attributes are the required default settings for the diagnostics. Be sure
your terminal is set to these attributes.
Note: Set these attributes before the diagnostics are loaded.
General
Setup
Attributes 3151
/11/31/41
Settings 3151
/51/61
Settings 3161/
3164
Settings Description
Machine mode 3151 3151
PC 3161
or
3164 The diagnostics are set to emulate
use of the 3161 ASCII Display
Terminal. If your terminal can
emulate a 5085, 3161, or 3164
terminal, use the attribute settings
in this table. Otherwise, refer to
your operator's manual, compare
the attribute setting descriptions in
this table with those of your
terminal, and set your attributes
accordingly.
Generated
Code Set ASCII
Screen Normal Normal Uses the EIA-232 interface
protocol.
Row
and
filemn 24 x 80 24 x 80 Uses the EIA-232 interface
protocol.
Scroll Jump Jump Jump When the last character on the
bottom line is entered, the screen
moves down one line.
Auto LF Off Off Off For the "On" setting, pressing the
Return key moves the cursor to
the first character position of the
next line. For the "Off" setting,
pressing the Return key moves the
cursor to the first character
position of the current line. The CR
and LF characters are generated
by the New line setting.
CRT saver Off Off 10 The "10" setting causes the display
screen to go blank if there is no
activity for 10 minutes. When the
system unit sends data or a key is
pressed, the display screen
contents are displayed again.
98 RS/6000 Enterprise Server Model H80 Series User's Guide